Uniden SC200 Operating Manual page 15

5. Press and hold
The VFO knob allows you to toggle through the
bands. Then press
search.
6. Press
scan. Also, press it to move to next higher channel or
frequency. Press and hold
search direction to upper side.
7. In Limit search, input the frequency and press
to program the lower/higher frequency. Press
to stop Band search, Limit search, and WX scan.
Also, press it to move to next lower channel or
frequency. Press and hold
search direction to lower side.
8. Press
you program frequency or Alpha characters. Press and
hold
Manual mode.
9. Use
programming a frequency into a channel. If you
make an entry error, press
key to erase the entry, and start over. Also, use
/ CLR to clear the error message display.
10. Press
CTCSS/CDCSS Data and Alpha characters into any
displayed channel.
11. Press
displayed channel, including Priority Channels. (L/O
appears on the display.) To unlock a channel, press
again.
Modes.
12. There are 10 Preprogrammed NOAA and Canada
weather channels. Press
NOAA and Canada weather channel in your area.
WX appears on the display in Weather Mode. If you
want to set or reset the Attenuator function, press and
hold
to stop Band serch, Limit search and WX
/ ALERT to change the display mode when
/ ALERT to set the Alert Beep function in
/ CLR to enter the decimal point when
to store a displayed frequency and
to "Lock Out" or prevent scanning of the
can be used for Scan or SEARCH
/ ATT .
/ BAND to start Limit search.
/ BAND again to start band
to change the
to change the
/ CLR before the
/ ATT to find the active
13