Using Ctcss Tone Or Cdcss Tone Search While Searching - Uniden SC200 Operating Manual

5.
Repeat Steps 1 - 4 to search for tones associated with
other stored frequencies.
If you want to program tones for several stored
frequencies, follow these steps:
After you program a CTCSS tone or CDCSS
n
tone with a stored frequency, the CTCSS Tone
or CDCSS tone Search Mode is canceled. The
CTCSS or CDCSS indicator remains on but
does not flash. To activate the CTCSS Tone
Search Mode or CDCSS Tone Search Mode
again, press and hold
short beeps.
If you decide to cancel the CTCSS Tone Search
Mode or CDCSS Tone Search Mode while
scanning, press and hold
short beeps and the CTCSS or CDCSS indicator
turns off.
You can select the CTCSS Search Mode or
n
CDCSS Tone Search Mode before pressing
flashing, and then press
When your scanner stops, the CTCSS Tone or
CDCSS Tone search begins immediately. If a
tone is found before the transmission ends,
press
frequency stored in the channel.
Using CTCSS Tone or CDCSS Tone Search
While Searching
1.
Set a Search Range.
For information about setting a search range, see Limit
Search on page 27.
2.
Press and hold
in Manual Mode. Simply, press and hold
until the CTCSS or DCS indicator begins
to program the tone with the
until you hear two short beeps.
until you hear two
until you hear two
.
33