Operation Overview - Uniden SC200 Operating Manual

Note: Before operating the SportCat for the first
time, make sure you have fully charged the Battery
Pack.
1.
Before turning on the scanner, rotate the Squelch
Control fully clockwise.
2.
Turn the scanner on by rotating the On-Off/Volume
Control clockwise until you hear a click. Turn the
Volume Control a small amount clockwise to a low
listening level.
3.
You should hear either a "rushing" noise or some
communications. If you are monitoring a transmission,
wait until it stops before adjusting the Squelch Control.
4.
Readjust the volume to a comfortable listening level.
5.
Turn the Squelch Control counterclockwise just until the
rushing noise disappears. At the squelch threshold, any
incoming signal just slightly stronger than the noise will
open the squelch. Any communication that is received
will open the Squelch, and stop scanning or Searching.
Note: If squelch is set too tight, that is, too far
counterclockwise from the threshold point, a much
stronger signal is required to open the squelch. If
squelch is set on a point clockwise from the
threshold, you will hear a constant sound (noise, if
no signal is present.) The scanner will not scan.
The SportCat has 200 memory channels, each of which can
be programmed to store one frequency. The channels are
divided into ten 20-channel banks, useful for storing similar
frequencies in order to maintain faster scanning cycles.
You can monitor communication in one of two ways:
n
BANK SCAN If you have programmed channels, you
can scan all programmed channels in the selected
bank(s), except locked out channels. When the scanner
stops on an active frequency, it remains on that channel
as long as the transmission continues. When the
transmission stops, the SportCat resumes scanning. If
the Delay Function is on, the scanner remains on the
same channel for 2 more seconds, waiting for a
responding transmission. If there is no responding
transmission within 2 seconds, the scanning cycle
resumes.

Operation Overview

17