NSK Primado2 Operation Manual page 14

P200-BMH and P200-BMH-HS Attachments/Handpieces
<Mounting>
1) Push the Attachment/Handpiece into the Motor straight.
2) Turn the Attachment/Handpiece rightward or leftward so that the Alignment Pin of
the Motor matches the hole of the Attachment/Handpiece with a clicking sound to
connect firmly.
3) Tighten the Removal Ring of the Attachment/Handpiece manually to fix it firmly.
<Removing>
Loosen the Removal Ring and pull out the Attachment/Handpiece from the Motor
straight.
P200-WPD Attachment/Handpiece
<Mounting>
Insert the Attachment/Handpiece straight into the Wire Pin
Driver until it clicks.
* Wire Collet or Pin Collet should be mounted with the Attachment/
Handpiece Lever facing down (Motor Cord side).
<Removing>
Pull the Attachment/Handpiece straight out while pressing the
Mounting/Removal Button of the Wire Pin Driver.
3-5 Mounting of the Irrigation Pole
Match the position of the convex part on the Irrigation Pole with the position of the groove in
the Irrigation Pole Stand located at the back of the Control Unit, and insert the Irrigation Pole
into the hole.
3-6 Mounting of the Irrigation Tube
1) By rotating the Knob towards OPEN, open the Pump Cover.
2) Insert the Irrigation Tube (part with no blue line) into the Irrigation Pump in such a manner that the needle side of the Irrigation Tube is
positioned on the right-hand side of the Pump, and securely place the stopper of the Irrigation Tube into the Guide Parts located at both
ends.
3) Rotate the Knob towards CLOSE to close the Pump Cover.
Knob
Fig. 10
Alignment Hole Alignment Pin
CLOSE
Attachment / Handpiece
Attachment /
Handpiece
Wire Pin
Driver
Guide Parts
Roller
Attachment /
Handpiece Side
Motor
OPEN
Fig. 7
Mounting/Removal Button
Fig. 8
Convex part on
the Irrigation
Pole
Groove in the
Irrigation Pole
Stand
Fig. 9
Irrigation Tube
Needle Side
Stopper
Irrigation Tube (with
no blue line)
Fig. 11
Knob
Fig. 12
13