NSK FX204 Series Operation Manual

NSK FX204 Series Operation Manual

Air motor
Hide thumbs Also See for FX204 Series:

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FX204 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for NSK FX204 Series

  • Page 4 • Do not attempt to disassemble the product nor tamper with the mechanism except as recommend by NSK in this Operation Manual. • Do not allow any impact on to the product. Do not drop the product.
  • Page 5 Authorized NSK Dealer. WARNING • Do not use high acid water or sterilizing solutions to wipe, immerse or clean the product. • Do not exceed the optimum pressure specified on the specification • The products are delivered in a non-sterile condition and must be table.
  • Page 6: Maintenance

    * F : Forward Rotation and overheating. If any abnormalities are found do not use the motor R : Reverse Rotation and contact your Authorized NSK Dealer. 8. Maintenance 6. Water and Chip Air Supply to the Handpiece After each patient maintain the product as follows.
  • Page 7 3) Connect the motor to the hose. Operate the motor for about 10 NSK PANA SPRAY Plus seconds. Apply NSK PANA SPRAY Plus every time after each use and/or before 8-3 Sterilization autoclaving. 1) Remove the motor from the hose.
  • Page 8 NOTICE 3) The motor should remain in the autoclave pouch until required for use. • NSK recommends Class B sterilizers as stated in EN13060. CAUTION 9. Periodical Maintenance Checks • Do not autoclave the product with other instruments even when it Perform periodical maintenance checks every three months, referring is in a pouch.
  • Page 9: Warranty

    NSK products are warranted against manufacturing errors and defects in materials. NSK reserves the right to analyze and determine the cause of any problem. Warranty is voided should the product be not used correctly or for the intended purpose or has been tampered with by unqualified personnel or has had non NSK parts installed.
  • Page 10: Specifications

    14. Specifications...

Table of Contents