Setting The Pulse/Tone Switch - Uniden XCAI680 Operating Manual

If the Battery icon begins to flash, the phone is programmed to eliminate its functions to save power.
The table below describes what to do to return your phone to normal operation.
DURING A CALL
Only the @ button operates.
The Handset beeps and the battery icon
flashes once everv 3 seconds.
Complete your call as quickly as possible.
Return the Handset to the Base Unit for
charging.
Note: Allow 15 to 20 hours without any interruption for the Handset fo fully recharge.
Battery Memory Effect
Rechargeable batteries can develop a "memory" (reduced charge capacity) caused by repeated
charge and discharge cycles. The battery life will seem to be shorter every time you use the unit.
To Avoid Memory Effect
At least once a month, operate the unit until the "Battery Low" indicator appears. Avoid "topping off"
the charge after using the phone for a short time. Also, do not charge the Rechargeable Battery for
extended periods of time.

Setting the Pulse/Tone Switch

Pulse/Tone
Be sure the
Note:
Most phone systems are tone dialing.
Check wifh your local phone company if you are not sure whether your system is tone
or pulse dialing.
switch is in the tone position.
IN STANDBY MODE
None of the buttons will operate.
The Handset beeps and the battery icon
flashes once everv 3 seconds.
You will not be able to make a call.
Return the Handset to the Base Unit for
charaina.
20