Setting The Pulse/Tone Switch - Uniden XCAI680 User Manual

If the Battery icon begins to flash, the phone is programmed to eliminate its functions to save power.
The table below describes what to do to return your phone to normal operation.
DURING A CALL
A
Only the button operates.
The Handset beeps and the battery icon
flashes once every 3 seconds.
Complete your call as quickly as possible.
Return the Handset to the Base Unit for
charging.
Note: Allow 15 to 20 hours without any interruption for the Handset to fully recharge.
Battery Memory Effect
Rechargeable batteries can develop a "memory" (reduced charge capacity) caused by repeated
charge and discharge cycles. The battery life will seem to be shorter every time you use the unit.
To Avoid Memory Effect
At least once a month, operate the unit until the "Battery Low" indicator appears. Avoid "topping off"
the charge after using the phone for a short time. Also, do not charge the Rechargeable Battery for
extended periods of time.

Setting the Pulse/Tone Switch

Be sure the PULSE/TONE switch is in the TONE position.
Note: Most phone systems are Tone dialing. Check with your local phone company if you are not
sure whether your system is Tone or Pulse dialing.
IN STANDBY MODE
None of the buttons will operate.
The Handset beeps and the battery icon
flashes once every 3 seconds.
You will not be able to make a call.
Return the Handset to the Base Unit for
charging.
PULSE-TONE
23