Table of Contents
Advertisement
NOTE
Allow 15 to 20 hours
without interruption for
the handset to fully
recharge.
TIP
Most phone systems use
tone dialing. Check with
your local phone company
if you are not sure
whether your system is
tone or pulse dialing.
CHARGING THE BATTERY PACK
Battery memory effect
Rechargeable batteries can develop a reduced charge capacity
caused by repeated charge and discharge cycles.
Rechargeable batteries that have developed this effect will
not operate to their fullest capacity.
To avoid memory effect, before recharging, operate the unit
until the rechargeable battery completely discharges. DO NOT
"top off" the charge by placing the handset on the base after
using for a short time.
To erase memory effect, operate the unit until the
rechargeable battery is completely discharged, then fully
recharge. Repeat this process at least 3 times.
Low battery indicator
When the battery pack is very low and
needs to be charged, the phone is
programmed to eliminate its functions
to save power. If the phone is not in use, the
LED flashes every 3 seconds and none of the
talk
buttons will operate. If you are using the phone,
the handset beeps and the
3 seconds. Complete your conversation as quickly
as possible. Return the handset to the base to
recharge the battery pack.
SETTING THE PULSE/TONE SWITCH
Be sure the PULSE/TONE
switch is in the TONE position.
continued
LED flashes every
talk
7
Advertisement
Table of Contents
