Auto Disconnect; Setting The Toll Saver Switch - Uniden XCAI680 Operating Manual

A tone will sound, and you will hear the preset message "Hello. No one is available to take
your call, please leave your message after the tone" on the Base Unit speaker. A second tone
sounds after the preset message plays, and the Answering System automatically returns to
Standby.
3. To select your recorded message again, press ogm.
The preset message will begin to play on the Base
Unit speaker.
4.
While the preset message is playing, press ogm again.
A tone will sound, and your recorded message will play on the Base Unit speaker. A second
tone sounds after your message plays, and the Answering System automatically returns to
Standby.
message will play twice to an incoming call and no message will be recorded.
Please make sure that your OGM message is properly set for the selected function.

Auto Disconnect

The Auto Disconnect allows your Answering System to disconnect and reset if the caller hangs up
before leaving a message. This prevents your Answering System from using recording time to
record a hang up/dial tone message.

Setting the Toll Saver Switch

The Ring Time/Toll Saver switch allows you to set the number of rings the caller hears before your
Answering System answers. You can set the switch to answer after 2 rings or after 4 rings. In the
TS (Toll Saver) position, the Answering System answers after 2 rings if you have new messages
recorded, and it answers after 4 rings if there are no new messages. So if you call long distance to
check your messages, you can hang up after the third ring and not be billed.
44