Control Functions; Main Switch; Indicator Lights And Warning Lights; Engine Stop Switch - Yamaha WR450FB 2012 Owner's Service Manual

Hide thumbs Also See for WR450FB 2012:
Table of Contents

Advertisement

EAS1DX3036
CONTROL FUNCTIONS
EASIDX3037
MAIN SWITCH
C-
The main switch controls the ignition and light-
ing systems. The various main switch positions
are described below.
ON
All electrical circuits are supplied with power;
the meter lighting, taillight and auxiliary light
come on, and the engine can be started.
TIP~~~~~~~~~~~~~~~
The headlight comes on automatically when
the engine is started and stays on until the main
switch is pushed to "OFF", even if the engine
stalls.
OFF
All electrical systems are off.
EWA1DX1001
AwARNING
Never push the main switch to
11
0FF
11
while
the vehicle is moving, otherwise
~he
electri-
cal systems will be switched off, which may
result in loss of control or an accident.
ECA1DX1003
--~~~~~~~~
Make sure that the main switch is in "OFF"
with the engine turned off, otherwise the
battery may discharge to the point that the
starter motor will not operate properly.
EAS1DX3038
INDICATOR LIGHTS AND WARNING
LIGHTS
1-20
CONTROL FUNCTIONS
C-
1. Engine trouble warning light ".a"
2. Fuel level warning light "i1"
Fuel level warning light "i1"
This warning light comes on when the fuel level
drops below approximately 3.0 L (0.79 US gal,
0.66 Imp.gal). When this occurs, refuel as soon
as possible.
The electrical circuit of the warning light can be
checked by pushing the main switch to "ON".
The warning light should come on for a few sec-
onds, and then go off.
If the warning light does not come on initially
when the main switch is pushed to "ON", or if
the warning light remains on, have a Yamaha
dealer check the electrical circuit.
Engine trouble warning light "
0 "
This warning light comes on or flashes if a prob-
lem is detected in the electrical circuit monitor-
ing the engine. If this occurs, have a Yamaha
dealer check the vehicle.
The electrical circuit of the warning light can be
checked by pushing the main switch to "ON".
The warning light should come on for a few sec-
onds, and then go off.
If the warning light does not come on initially
when the main switch is pushed to "ON", or if
the warning light remains on, have a Yamaha
dealer check the electrical circuit.
EAS1DX3039
ENGINE STOP SWITCH
The engine stop switch
11
1
11
is located on the left
handlebar. Continue pushing the engine stop
switch till the engine comes to a stop.
1

Advertisement

Table of Contents
loading

Table of Contents