Yamaha WR450FB 2012 Owner's Service Manual page 171

ECA14250
-·
------------
• First, tighten the bolts on the front side of
the upper handlebar holder, and then on
the rear side.
• Turn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
~b
HANDLEBAR
c
dg
~
§
+ 2 -
fi
3. Tighten:
• Lower handlebar holder nuts
4. Install:
Lower handlebar holder nut
34 Nm (3.4 m·kgf, 25 ft-lbf)
• Handlebar grip "1"
TTTTTTTTTTTTTTTTTTTTTTTTTTTTTTTT
a. Slightly coat the handlebar left end with a
rubber adhesive.
b. Install the handlebar grip on the handlebar
by pressing the grip from the left side.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13120
j \
WARNING
Do not touch and move the handlebar grip
until its adhesive dries completely.
TIP _ _ _ _ _ _ _ _ _ _ _ _ _ _
Install the handlebar grip to the handlebar so
that the line "a" between the two arrow marks
faces straight upward.
5-40