Yamaha WR450FB 2012 Owner's Service Manual page 84

1. Clutch cable
2. Hose guide
3. Engine trouble warning light coupler
4. Auxiliary light lead
5. Clutch switch coupler
6. Engine stop switch coupler
7. Main harness
8. Resistor coupler
9. Headlight coupler
1 O. Brake hose
11. Auxiliary light coupler
12. Meter assembly coupler
13. Meter assembly lead
14. Speed sensor lead
15.Guide
16. Main switch coupler
17. Meter assembly optional switch coupler
18. Speed sensor coupler
19. Right handlebar switch lead
20. Throttle cable
21 . Engine stop switch lead
22. Meter assembly
23. Main switch
A. Pass the brake hose through the guide.
B. After putting the resistor rubber band projection in
the meter bracket, firmly secure the resistor by
sliding it downward.
C. Make sure to securely fix the main harness clip
while pushing it in the round hole in the meter
bracket on the inside of the vehicle.
D. Fix the auxiliary light coupler while inserting it in
the hole in the head light unit.
E. Pass the speed sensor lead through the guide.
F. Clamp the right handlebar switch lead to the han-
dlebar.
G. Pass the throttle cable and clutch cable between
the upper bracket and the meter bracket.
H. Clamp the engine stop switch lead and clutch
switch lead to the handlebar.
CABLE ROUTING
2-38