Yamaha WR450FB 2012 Owner's Service Manual page 76

Hide thumbs Also See for WR450FB 2012:
Table of Contents

Advertisement

1 . Protector
2. Main harness
3. Intake air pressure sensor coupler
4. Throttle position sensor coupler
5. Connecting arm
6. Catch tank breather hose
7. Condenser
8. Starter motor lead
9. Coolant temperature sensor lead
1 O. Neutral switch lead
11. Ignition coil coupler
12. Ignition coil
A.
Put the end of the fuel tank breather hose in the
hole in the steering stem.
B. Pass the leads under the hose connecting both
(right and left) radiators.
C. Attach the grommet by pressing it against the end
face of the protector.
D. Apply an adhesive to the grommet before fixing it.
E.
Pass the leads so the engine breather hose is lo-
cated on the outside of the vehicle.
F. Pass the main harness over the intake air pres-
sure sensor coupler.
G. Clamp the condenser lead and coolant tempera-
ture sensor lead. Lay the leads and the locking in
any direction.
H. Pass the catch tank breather hose between the
cross tube (on the frame) and the connecting
arm.
I. Insert the condenser in the bracket before fixing
it.
J.
Degrease the condenser on its surface having no
lead coming out before affixing the insulation to it.
When affixing the insulation, align its notch with
the projection on the condenser. When the insu-
lation materials overlap, affix them so that the lon-
ger one is directed toward the rear of the vehicle.
K.
Fix the neutral switch lead to the down tube (on
the frame). Lock it on the outside of the vehicle
with its allowed portion directed upward. Do not
cut off the lead end.
L.
Pass the neutral switch lead on the outside of the
vehicle away from the bracket.
M. Clamp the AC magneto lead, neutral switch lead,
and ignition coil lead. The leads may be laid out
in anyway.
N. Pass the ignition coil lead (from coupler to ignition
coil) in the rear of the radiator hose.
0. Pass the neutral switch lead on the inside of the
vehicle away from the engine bracket.
P. After installing the ignition coil onto the bracket,
put a cover over them.
Q.
Pass the main harness through the cable guide.
CABLE ROUTING
2-30

Advertisement

Table of Contents
loading

Table of Contents