Yamaha WR450FB 2012 Owner's Service Manual page 36

Resetting average speed (AVS) and tripmeter
A (TRIP A)
1. Check that the timer is in operation. If the
timer is not in operation, start the timer by
pushing the
11
SLCT1
11
button and
11
SLCT2
11
button at the same time.
2. Reset tripmeter A (TRIP A) display and the
average speed display by pushing the
11 RST 11 button for 2 seconds or more.
TIP _ _ _ _ _ _ _ _ _ _ _ _ _ _
If reset,
~
,
fiJ ,
the travel distance display,
and average speed display will go on flashing
for four seconds.
alsLCT1
I
~
fJ
I
SLCT2
I
,-,
' I / - . , -
_nn,
1 / . _
u.u
,flW:j'J
I '
/ I / I ' -
Resetting average speed (AVS), tripmeter A
(TRIP A) and timer
1. Check that the timer is not in operation. If the
timer is in operation, stop it by pushing the
11
SLCT1" button and
11
SLCT2" button at the
same time.
2. Reset all measured data by pushing the
11
RST
11
button for 2 seconds or more.
TIP _ _ _ _ _ _ _ _ _ _ _ _ _ _
• Resetting will reset the timer display, travel
distance display, and average speed display
and put measurement on standby.
• Auto start attempt will put measurement on
standby as such. Likewise, manual start at-
tempt will put measurement on standby as
such.
@' S lCTl
I
o n.
'5
·ng t-
1-1
LI· I ·U ,..
~
~
s
1n
:f ...
1LI
I
SLCT2
I
IU.3
fN§MPH
!
o n-nn-nn
,,
Ll·UU·LILI
s
,-,n
,_,
u.u
IN§MPH .
1-27
MUL Tl-FUNCTION DISPLAY
Correcting tripmeter A {TRIP A)
1. Change the travel distance display by push-
ing the ."SLCT1
11
button (plus) or "SLCT2 11
button (minus). A long push on the button
will fast-forward the change.
TIP _ _ _ _ _ _ _ _ _ _ _ _ _ _
• Change can be made any time while timer
measurement is or is not being made.
•Change in the travel distance display will be
accompanied by the change in the average
speed display.
Correcting tire diameter
IQ3
10.
'-I
EB
/Q218
TIP _ _ _ _ _ _ _ _ _ _ _ _ _ _
• Correction can be made any time while timer
measurement is or is not being made.
• Change in the travel distance display will be
accompanied by the change in the tire•s dia-
metric percentage.
• Even back in BASIC MODE, the tire diameter
set in RACE MODE will be retained.
• Correction to the tire diameter is impossible if
the tripmeter indicates 11 0 11
•
• If the machine is run while the tire diameter is
being corrected, the tire's diametric correction
will be cancelled forcedly.
1. Push the
11
SLCT1
11
button and "Rsr· button
for 2 seconds or more at the same time and
enter tire diameter correction mode.
TIP _ _ _ _ _ _ _ _ _ _ _ _ _ _
Changeover to tire correction mode will cause
the timer display to change and show the dia-
metric digit of the tire.
2. Change the digits of the travel distance by
pushing the "SLCT1
11
button (plus) or
11
SLCT2
11
button (minus). A long push on the
button will fast-forward the change in digits.