Nice ALTO100C Instructions And Warnings For Installation And Use page 3

In this manual, the text "ALTO system" refers to the entire series of devices that make up the automation.
This manual describes how to set up a complete automation, such as that shown in
and accessories are optional and may not be present in the kit. For a complete description, refer to the Nice Home
product catalogue or visit the website www.niceforyou.com.
performed. Therefore, to facilitate installation and programming, and to ensure personal safety, read the manual
, to ensure full comprehension of the tasks to be performed, and then perform the work itself, completing all
tasks in the order in which they are described.
KNOWLEDGE OF THE PRODUCT AND PREPARATION FOR INSTALLATION
––– STEP 2 –––
2.1 - PRODUCT DESCRIPTION AND INTENDED USE
The series of devices and accessories stated in this manual (some of
which are optional and not present in the kit), make up the automation
system named "ALTO", designed for a gate or door with one or two swing
leafs.
conditions other than as stated in this manual is to be considered
improper and is strictly prohibited!
The main part of the automation comprises one or two electromechanical
gearmotors (depending on the number of leafs to be automated), each
equipped with a DC motor and epicyclical gear reducer. The geamotors
have an articulated arm, the length of which can be shortened during
or other) preventing complete rotation of the arm and therefore maximum
leaf opening.
The ALTO100C is equipped with a control unit that powers and manages
operation of all connected devices. The control unit implements "ECS-
Bus" technology, which enables connection and communication between
multiple devices, using a single bus cable with 2 internal wires. The control
unit incorporates a radio receiver for reception of the commands sent by
the user by means of the ECCO5... transmitter. The system can memorise
up to 256 transmitters (if memorised in "Mode I") and up to 6 pairs of
PH200 photocells.
The automation can be powered by the mains (230 V) or alternatively by
the SOLEKIT photovoltaic system. If powered by the mains, a backup
battery (mod. PR200, optional accessory) can be installed in the control
unit to enable a number of emergency manoeuvres following a power
failure (black-out). During the power failure, or at any other time, the gate
using the relative key.
2.2 - DEVICES AND ACCESSORIES REQUIRED TO SET
UP A COMPLETE SYSTEM
Fig. 1 illustrates all devices and accessories required to set up a complete
system, such as that shown in
[a] - Electromechanical gearmotor ALTO100C with control unit
[b] - Electromechanical gearmotor ALTO100M without control unit
[c] - Curved arms + slotted arms
[d
[e
[f] - Keys for manual release of gearmotors
[g] - Pair of photocells PH200 (wall-mounted)
[h] - Hand-held transmitter ECCO5...
[i] - Flashing light FL200
[l
[m] - Buffer battery PR200
Warning! - Some devices and accessories stated herein are
optional and may not be present in the kit (refer to the Nice Home
product catalogue).
Important notes on manual consultation
.
1
[b]
[a]
[c]
[d]
[g]
[h]
[l]
. Some of these devices
[e]
[f]
[m] [i]
English – 2