Nice ALTO100C Instructions And Warnings For Installation And Use page 12

15
7
11 – English
2
5
3.
1
it is aligned in contact with the travel stop and aligned with the other
leaf (if present). Caution! - If necessary, repeat point 2 to obtain per-
fect closure.
09.
a)
already performed in phase 08).
b) - Drill a hole in the leaf at the same point as the hole at the centre of the
bracke
the three screws fully down.
c)
10. Manually locking the gearmotor
a) - Manually move the leaf to approximately mid-travel and lock the
gearmotor by means of the special key (refer to chapter "Manually
locking and releasing the gearmotor" in the "Operation Manual").
Then manually move the leaf by a few centimetres in the opening
3
direction.
11. On 2-leaf gates.
a) - If the gate has two leafs, install the other gearmotor repeating all
operations described in paragraph 3.4 and in this paragraph.