Advertisement
Your Brillion Subsoil Chisel Plow is shipped to you in separate assemblies. Before assembling the unit,
separate the various bundles and open the box assembly, taking care not to lose any of the parts or hardware.
(Refer to repair parts section for relative location of parts.)
1. Block up the frame or mount it to
the three point hitch on the tractor
for the assembly of shanks and
gage wheels, if your machine is so
equipped. See repair parts section
on gage wheels which shows how
they are assembled to the frame.
2. Assemble the center shank,
as shown in Figure 1, with the
angles, plate and hardware
provided. Be sure to use the
1/4 x 2 x 11 7/16" long shim
straps under the 1J497 plate
as illustrated.
Refer to page 7, repair parts
section, for proper hardware
usage.
3. Next, assemble the outer shanks.
For each shank, mount to the frame tube:
1. plate weldment
2. 1J495 plate
3. shank mounting angles
Note: Make certain that you use the
positions nearest the lower 3-point hitch lugs on the frame
provide clearance at the hitch lugs when using a 19" or 20" shank spacing. Figure 2A.
Use the 3/4" x 8" long bolts in front and the 5/8" x 8" long bolts in the rear, but do not tighten at this
time. (Refer to pages 6 and 7 of the repair part section for position of parts.)
4. Assemble the shank between the mounting angles and install the bolts through the angles, shanks and
locknuts as shown, with two 5/8" x 3 3/4" long bolts at the front and a 3/4" x 3 1/2" bolt at the rear.
TIGHTEN THESE BOLTS UNTILTHE ANGLES ARE JUST SNUG AGAINST THE SHANK. DO NOT
OVERTIGHTEN. THE BOLTS SHOULD BE EASILY TURNED WITH A WRENCH ON THE BOLT HEAD
WHEN CORRECTLY TIGHTENED. OVER TIGHTENING THESE BOLTS WILL NOT ALLOW THE SHANK
TO PIVOT AND SHEAR THE FRONT BOLT IF AN OBSTRUCTION IS HIT. The front bolt that is installed
through the angles is designed only to keep the angles from spreading if the front shank bolt shears.
5. Now, adjust your shanks to the center distance desired and tighten the vertical clamping bolts.
973rev401
SET-UP INSTRUCTIONS
Mast
Plate
Shim Strap,
1/4" x 2" x 11 7/16"
Trimmed
Angles
1J700, 1J701, 1J702, and 1J703
Page 3-[a]
Angle
Center
Shank
mounting angles at the
. These angles are trimmed to
FIGURE 1
Frame
FIGURE 2A
1J534
Advertisement
