Chain Dialing - Uniden UIP 160P Series Owner's Manual

note
•The pause key counts
as one digit. Pressing
∨
redial/p/vol/ more
than once increases the
length of the pause
between numbers. Each
pause represents a 2
seconds delay.
•If you choose not to
store a Distinctive
Ring, simply select the
"No Selectn" option.
•If you choose not to
store the name/
number as a Speed
Dial, simply choose the
"No Selectn" option.
[ 3 9 ] PHONEBOOK (STORING PHONE NUMBERS, NAMES, DISTINCTIVE RINGS AND SPEED DIAL)
4) Press the OK soft key to store the name;
appears.
S t or e/ E di t N o .
5) Use the number keypad,
phone number (up to 20 digits).
If you make an error, use the DELETE soft key to erase the incorrect digits. When
you are finished, press the OK soft key to store the number.
6) appears. Press cid/vol/
D i st in c ti v e R in g
∨
vol/ to move the pointer to one of the Distinctive
Ring options and then press the OK soft key.
7) appears. Press cid/vol/
S p ee d D ia l
to move the pointer to select the Speed dial location
(10 locations: SPD1-SPD0).
8) Press the OK soft key. You will hear a confirmation
tone, and appears in the display.
D on e!

Chain Dialing

The phonebook entries in the handset are not limited to phone numbers. You can
also store a group of numbers (up to 20 digits) that you need to enter once your
call connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store the account number in one of
the phonebook entries (refer to "Phonebook (Storing Phone Numbers, Names,
Distinctive Rings and Speed Dial)" on page 38). When you call your bank and are
prompted to enter the account number, scroll through your phonebook entries until
you find your account number, and then press the DIAL soft key.
< >
/tone/ , or #/ to enter the
*
∧
or redial/p/
∧
or redial/p/vol/
∨
w w w . u n i d e n . c o m