Chain Dialing; Memory Dialing (Base Only) - Uniden DSS2465 Quick Start Manual

UP308BH (DSS2465) ENG OM 1/14/05

CHAIN DIALING

The memory locations in the handset are not limited to phone numbers. You can
also store a group of numbers (up to 20 digits), that you need to enter once your
call connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store a special number in the
phonebook location (refer to "Storing Phone Numbers, Names, Distinctive Rings and
Speed Dial" on page 29). Once you have called your bank, and when you are
prompted to enter the account number, just as you do when viewing the phonebook
location, view the special number, then press the DIAL soft key.

MEMORY DIALING (base only)

You can store 10 phone numbers in the base, and make calls with memory dialing
• The 10 memory
from the base.
locations in the base
are independent from
Storing Phone Numbers
the handset.
1) Press
• If you have not
2) Enter the number you wish to store. (The number cannot exceed 20 digits.)
pressed any key for
3) Press
30 seconds, the
You will hear a confirmation tone.
phone returns to the
standby mode.
Deleting the Stored Data
• If you make or
1) Press
receive a call, the
operation is canceled.
2) Press
3) Enter the memory location number (0-9) you wish to delete.
You will hear a confirmation tone.
Making Calls with Memory Dialing
1) Press
2) Press
[ 36 ]
11:47 AM Page 36
in the standby mode.
. Enter the memory location number (0-9) on the keypad.
in the standby mode.
again.
(talk) in the standby mode.
. Enter the memory location number (0-9) to dial the number.
Get other manuals https://www.bkmanuals.com