YASKAWA E-V Series User Manual page 17

1 Overview of Setup
This chapter describes the flow of the setup procedure from installation until a JOG
operation. A digital operator and an engineering tool called SigmaWin+ that can be
used with a PC are available to set up a servo drive.
• An alarm or warning may be generated if communications are executed with the
host controller during operation using SigmaWin+ or the digital operator.
If an alarm or warning is generated, the process currently being executed may be aborted
and the system may stop.
Install the servomotor and
SERVOPACK.
Perform the required wiring and
connections for a JOG operation.
Perform a JOG operation for the
servomotor using the digital operator
or SigmaWin+.
1-2
• Be sure to read 4.2 Inspection and Checking before Trial Opera-
tion.
• The digital operator is available for both SERVOPACKs with ana-
log voltage reference and SERVOPACKs with pulse train refer-
ence.
Operation
↓
↓
CAUTION
Reference (in this manual)
Chapter 2 Installation
Chapter 3 Wiring and Connection
Chapter 4 Trial Operation (Checking
Servomotor Operation)
Trial Operation Using the Digital
Operator
→4.3 JOG Operation Using a Digital
Operator
Trial Operation Using SigmaWin+.
→4.4 JOG Operation Using
SigmaWin+