Setting The Centrifugal Force (Rcf); Setting The Temperature (Temp); Cooling - Labnet Prism R User Manual

the display will flash. Turn the
decrease the value. Press
or press (START/STOP) knob to store and run the selection. The
flashing of RPM value will stop and the RPM value will be stored
automatically if no button is pressed after 6 seconds of the
adjustment.

Setting the Centrifugal Force (RCF)

5.3.
The speed can be selected from 20 to 17,200 x g, too. Press
button to change the RCF setting. The 5 digits of RCF on the display
will flash. Turn the
the value. Press
(START/STOP) knob to store and run the selection. The flashing
of RCF value will stop and the RCF value will be stored automatically
if no button is pressed after 6 seconds of the adjustment.

Setting the Temperature (TEMP)

5.4.
The temperature can be selected from -10 to 40° C. Press
to change the temperature setting. The 2 digits of temperature on the
display will flash. Turn the
decrease the value. Press
or press (START/STOP) knob to store and run the selection. The
flashing of TEMP value will stop and the value will be stored
automatically if no button is pressed after 6 seconds of the
adjustment.

Cooling

5.5.
The temperature can be set from -10 ° C and + 40 ° C. The set
Prism R™ Refrigerated Microcentrifuge
(START/STOP) knob to increase or
button again to confirm the selection
(START/STOP) knob to increase or decrease
button again to confirm the selection or press
(START/STOP) knob to increase or
button again to confirm the selection
button
11