Advertisement
"Low Power" means that the SDA-2400 will turn on automatically when it detects a signal on the selected
input. If a signal is not detected for around 30 minutes, the amplifier will go into standby mode. "On" will keep
the SDA-2400 permanently turned on. When a trigger cable is used, the Power State must be "On".
3-4. Analog unbalanced and balanced input
For connection to products with analog output, you may only connect to one input at a time. The input
sockets are internally connected in parallel, so ALWAYS use EITHER the XLR inputs OR the phono inputs.
Do not use both at the same time, as this will induce noise.
5-6. Coaxial input and optical input
For connection to products with digital output, Coaxial (SPDIF) and Optical (Toslink) inputs are available.
7. Input select
Set the selector to the input in use.
8. Loudspeaker connectors
Connect your speakers to Left and Right connectors. The connectors allow for use of banana plugs and bare
wire up to 5mm2.
9. Voltage selector
The voltage selector must be in the position for your local mains supply.
10. Mains connector and switch
Be sure that the power cord is inserted firmly in the connector. The mains switch will remove the amplifier
from your mains power.
Connection guide
When connecting the speakers, always connect + and - from the
amplifier to the corresponding + and - terminals on the speaker.
Warning: Never run the SDA-2400 in so-called "bridge mode."
Bridging the speaker output terminals will damage the amplifier.
Never connect speaker cables to 'high-level' inputs on a
subwoofer, as this will damage the SDA-2400.
Lyngdorf Audio SDA-2400 – Owner's manual
6
Advertisement
