ESDEC CLICKFIT BASIC Manual page 4

Edge zone
The distance from the solar panels to the side of the roof, gutter and ridge should be determined according DTI GUIDE 2nd
addition. No solar panels should be placed in this zone as a whole or in part.
Dimensions
All sizes and dimensions are in centimetres, unless stated otherwise.
Standards, prescriptions and regulations
Upon installation of the mounting system, it is important to follow the installation manual and the associated standards to
prevent accidents. Keep the following standards, prescriptions and regulations particularly in mind:
Buildings Decree Construction
•
PPE Personal Protective Equipment
•
KEMA Inspection of Electrico-technical Materials
•
DIN 1055 Design overloads for buildings
•
DIN 18299 General rules for all construction sectors.
•
DIN 18451 Scaffolding
•
BS7672
•
MCS and MIS standards
•
Building and planning regulations
•
Health and safety
•
DTI Guide 2nd addition
•
Planning and building works notification
Make sure to notify the applicable bodies in regards to planning and building works.
Support
For technical or customer support please contact:
Esdec BV
Paderbornstraat 4
7418BP Deventer
The Netherlands
Tel: +31 570 624 177
email: info@esdec.nl, info@click-fit.com
or contact your local dealer/distributor.
Removal and demounting
Remove the product according to local laws and regulations.
Guarantee and maintenance
Guarantee and maintenance according to general terms and conditions and guarantee terms of Esdec BV. These can be
found on the website www.esdec.nl or www.click-fit.com
Liability
The manufacturer accepts no liability for damage or injury caused by not (strictly) adhering to the safety prescription and
instructions contained in this manual, or by carelessness during installation of the product specified in this document and
the eventual related accessories.
• printing errors may occur
Rev. 20.01.14 ASSEMBLY MANUAL FOR STEEL ROOFS
02