Create A Software Backup - Unify Wireless Service Gateway WSG Administrator Documentation

Software Administration
It is not recommended to use the module's Management port when installing software.
1) Click "Configuration" on the start page.
2) Select Software > Installation in the menu on the Configuration page.
3) Select software (.pkg) to upload. The software will replace the not running software.
4) Select "Switch immediately" if you want to run the new software.
5) Select "Copy current settings" if you want the new software to inherit the settings currently
used. This selection will have no effect if the software type is different than the currently used
software. The module will always start up using factory settings if the software type differs.
6) Click the "Start Installation" button.

Create a Software Backup

It is recommended to now and then create a backup of the software configuration.
1) Click "Configuration" on the start page.
2) Select Software > Installation in the menu on the Configuration page.
3) Click the "Backup" button.
Note that the backup will contain configuration for the running software only.
86
A31003-M2000-M105-01-76A9, 29/06/2020
Wireless Service Gateway WSG, Administrator Documentation