Table of Contents
Advertisement
2.1.2 2.5" SATA SSD/HDD Installation
You can install one 2.5" SATA SSD/HDD inside the NVR.
1.
Make sure the NVR is power-off.
2.
Unscrew the four screws on the bottom cover and then remove the bottom cover from the
housing.
3.
Turn the bottom cover to the other side. Place an 2.5" SATA SSD onto the inner side of the
bottom cover, align the SSD screw holes, and then use the supplied 4 screws to screw the
SSD to the bottom cover from the outside of the bottom cover.
2.5" SATA SSD
4.
Connect one end of the supplied SATA cable and SSD power cable to the motherboard.
Inner side of the Bottom Cover
SATA Cable
7
eIVP5600 AI Mobile NVR
SSD Power Cable
Advertisement
Table of Contents
