Table of Contents
Advertisement
2. Basic Installation
2.1 Hard Disk Installation
You can install two 3.5" HDDs inside the NVR for recording videos. The maximum capacity of
each HDD is 8TB.
1. Make sure the NVR is power-off.
2. Unscrew the eight housing screws (4 on the rear panel, 2 on the left and right side each). To
remove the housing cover from the NVR, push the cover backward and then lift it.
3. Find the SATA cable inside the NVR, and connect the SATA cable to the SATA port on the HDD
(left image). Find the internal power cable, and connect the internal power cable to the HDD
(right image).
4. Place the HDDs inside the NVR, screw the HDDs from the bottom side of the NVR using the
supplied Screws.
5. Screw the housing cover back to the NVR.
3
Advertisement
Table of Contents
