Ssd Installation - EverFocus eNVP-JNN-IV-V0008 User Manual

2.3 SSD Installation

Users can install one 2.5" SSD into the AI mobile NVR for recording. Please follow the steps
below to install the SSD.
Note: The AI mobile NVR does not support hot swap for the SSD. Ensure to power off the
device before removing the SSD. Also ensure to remove the SSD only after the power was
completely shut off. This would protect and extend the operating life of the SSD.
1. Make sure the AI mobile NVR is powered-off. Unlock the SSD Tray (turn clockwise) using the
supplied SSD Lock Key.
2. To install the SSD, pull the Release Latch to open the SSD Tray Arm.
Release Latch
3. Insert an SSD into the SSD tray and then push back the SSD Tray Arm.
Note: The models support SSD height with 7mm and 9.5mm. If 7mm SSD is in use, it is
strongly recommended to use a spacer to increase the SSD height from 7mm to 9.5mm to
prevent from wobbling and vibration.
4. Lock the SSD Tray using the supplied SSD Lock Key.
eNVP-JNN-IV-V0008 / eNVP-JTX-IV-V0008 / eNVP-JNX-IV-V0008
SSD Tray Arm
9
Unlock
Lock