Set Up Of The Hardware For Repeater Programming; Programming The Spectralink Dect Repeater With The Handset And Repeater Management Tool - SpectraLink IP-DECT Server 200 Installation And Configuration Manual

Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide

Set up of the Hardware for Repeater Programming

It is recommended that you carry out the set up in the following order:
1. Unplug the repeater power supply and insert the splitter into the power socket of the repeater.
2. Connect the repeater power supply (small one - RJ9) to the splitter and the mains.
3. Wait until the LED flashes (starts with solid red - goes to flashing red after 3 sec.)
4. Connect the programming plug (RJ11) to the splitter.
5. Connect the USB cable to the programming tool.
6. Download the Handset and Repeater Management Tool from
and install it on your computer.
The repeater is now ready for programming via the Handset and Repeater Management Tool.
Programming the Spectralink DECT Repeater with the Handset and Repeater Man-
agement Tool
The Handset and Repeater Management Tool is the tool you access from your desktop and use for
repeater programming, handset management and software download to the handset.
The Handset and Repeater Management Tool identifies the type of repeater, and with this software
it is possible to program the Spectralink DECT Repeater to connect to the Spectralink DECT Radio
Infrastructure solutions.
For more information about programming the repeater with the Handset and Repeater Management
Tool, refer to the Handset and Repeater Management Tool User Guide.
Note:
Before you start programming the repeater, ensure that the repeater is connected to the
computer and the mains.
14215700-IG, Edition 15.0
May 2020, Original document
http://support.spectralink.com/
104