Table of Contents
Advertisement
Connecting the Base and Charging the Handset
)
Connect.the.AC.adapter.to.the.DC.IN.9V.jack.
CAUTION: To avoid risk of fire and shock, only use the Uniden
AD-800.AC.adapter.
2)
Connect.the.AC.adapter.to.a.standard.20V.AC.wall.outlet...
DO.NOT.use.an.AC.outlet.controlled.by.a.wall.switch..
3)
Place.the.handset.in.the.base.with.the.LCD.screen.facing.forward.
4)
Make.sure.that.the.charge.LED.illuminates..If.the.LED.does.not.
illuminate,.check.to.see.that.the.AC.adapter.is.plugged.in.and.the.
handset.makes.good.contact.with.the.charging.contacts.
5)
Charge.your.handset.at.least.5.to.20.hours.before.plugging.into.
the.phone.line.
Installing the Belt Clip
Line.up.the.holes.on.each.side.of.the.handset..To.attach.the.belt.clip,.insert.into.
the.holes.on.each.side.of.the.handset..Press.down.until.it.clicks.
To remove the belt clip,.pull.either.side.of.the.belt.clip.to.release.the.tabs.from.
the.holes.
6
To AC outlet
To AC outlet
To DC IN 9V
To DC IN 9V
AC adapter (supplied)
AC adapter (supplied)
Advertisement
Table of Contents
