Front Panel; Motor And Mounting Bracket - Amana Speed Queen AWM190W2 Service Manual

13.
FRONT PANEL (Figure 20)
a. Remove two screws from bottom edge of
front panel.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
Hold-Down Clips
Compress hold-down clips enough to remove
them from slots in top flange of panel.
Guide Lugs
Remove screws holding guide lugs to side
flanges of front panel.
Brace
Remove screws holding brace to side flanges
of front panel. Remove brace from front panel
by swinging one end toward bottom of front
panel and remove brace.
FRONT PANEL
SCREWS
14. MOTOR AND MOUNTING BRACKET
a. Remove two screws from bottom edge of
front panel, Figure 20.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slot3 in cabinet top.
IMPORTANT: There will always be some water that
will remain in outer tub, therefore, before
removing hoses from pump, hoses must be
pinched off or drained to prevent water spillage.
c. Loosen hose clamps and remove hoses from
pump assembly,
Figure 21.
d. Unhook idler spring from clip on front of motor
mounting bracket,
Figure 21.
IMPORTANT: Use
c=r·
when releasing idler lever
tension. If idler spring is ove~stretched, washer
operation will be affected.
HOLD-DOWN
CLIP
CABINET TOP
HOLD-DOWN
SCREWS
W223SE3A
Figure 20
17
(continued)
RS31J0002 (37400R3)
Rev. 3