Section Ill - Adjustment; Leveling Legs - Amana Speed Queen AWM190W2 Service Manual

SECTION Ill
Adjustments
31. LEVELING LEGS (Reier to
Figure 48)
a. Place rubber feet on all four leveling legs.
b. Place washer in position on a clean, dry, and
reasonably
firm floor.
c. Loosen locknuts and adjust two front
leveling legs. Once adjusted, tilt unit forward
on front legs and lower back down into
position to set the rear self-leveling legs.
d. Washer must not rock. After washer is at
desired height, tighten locknuts securely
against bottom of washer base. If these
locknuts are not tight, washer will not remain
stationary during operation.
NOTE: Improper installation, installation on carpet
or flexing of a weak floor will cause excessive
vibration.
IMPORTANT: Do not slide washer across floor
once leveling legs have been extended, as legs
and base could become damaged.
57
WASHER
BASE
RUBBER
FOOT
LEVELING
LEG
Figure 48
W161SE1A.
RS3100002 (374DDR3)
Rev. 3