Table of Contents
Advertisement
p. Through
Serial
No. 9606029040 -
Use a right angle needle nose pliers and
remove brake spring from around lower
transmission tube (located inside brake
assembly).
NOTE: Remove brake spring by turning in a
COUNTERCLOCKWISE direction (looking at
bottom end of shaft).
IMPORTANT: When installing brake spring (if
used), make sure it is inserted into groove in large
splines of lower transmission tube. Use spring
tool, No. 242P4, for installing brake spring.
NOTE: When reassembling, place a small amount
of No. 03200P Lubricant to t'.'.: · side o: drive pulley
that will be contacting large flat washer. Lubricate
helix ramps and bore with a small amount of
No. 03200P Lubricant, Figure 42.
IMPORTANT: DO NOT OVER LUBRICATE!
Excess lubricant can be thrown into pivot dome
area during normal washer operation. Any
lubricant on the pivot dome or snubber pad and
isolator assembly will cause premature tripping of
the out-of-balance switch. This condition will
persist until lubricant is removed.
q. Remove three screws and rubber sleeves
holding brake pads to lower bearing housing,
Figure42.
r. Lift brake assembly and pads off transmission
tube.
s. Remove three screws holding lower bearing
housing to tub support legs, Figure 42.
t.
Rotate bearing housing past legs, then
carefully lift bearing housing off transmission
tube.
NOTE: It may be necessary to loosen one leg from
outer tub to rotate housing. Tap lightly on housing
to loosen it from transmission tube.
IMPO.RTANT: When installing lower bearing
housing, apply No. 27604P Anti-Seize Compound
to the area of transmission tube that will be
contacting bearing, Figure 43.
47
TO REMOVE BEARING
a. Support bearing housing around outside
diameter of bearing opening and carefully
press bearing out of the housing.
b. Clean all foreign material from inner diameter
of bearing opening.
c. Clean any foreign material from outside
diameter of new bearing.
d. Apply a retaining compound (such as Loctite)
to outside diameter of new bearing and
carefully press new bearing into housing (with
sealed side facing up).
IMPORTANT: Press new bearing into housing by
pressing on outer race of bearing only, and press
until bearing bottoms out in housing.
27. TRANSMISSION ASSEMBLY
a. Open loading door.
b. Remove agitator by placing two agitator
hooks, No. 254P4P, under bottom edge of
agitator, Figure 12.
IMPORTANT: Hook& should be positioned 180
degrees of each other, and must be placed under
agitator vane for greater stability. If hooks are
placed between vane area, damage to agitator
may occur.
c. Usio1g a rocking motion (back and forth)
carefully lift agitator off drive bell.
d. Remove two screws from bottom edge of
front panel, Figure 20.
e. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top
Figure 20.
'
f. Remove two cabinet top hold-down screws,
and hinge cabinet top or remove,
paragraph 18.
g. Loosen hose clamp and disconnect filler hose
from outer tub cover, Figure 32.
NOTE: When reinstalling filler hose, the white line
or hose that connects to tub cover must be
aligned with line located on top side of outer tub
cover, Figure 32.
I continued)
RS3100002
(37400R3)
Rev. 3
Hide quick links:
Advertisement
Table of Contents
