Removing The Rear Panel Components - Amana NTW5200T Technical Education

REMOVING THE REAR PANEL COMPONENTS

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Remove the console and position it back
out of the way (see page 4-2 for the pro-
cedure).
3. Rotate the cabinet forward so you can
access the rear panel components.
The following rear panel components are ser-
viced in this section:
• Vacuum Break
• Water Inlet/ATC Sensor
• Motor Start Capacitor
• Drain Hose Bucket
4. To remove the vacuum break:
a) Loosen the clamp and disconnect the
b) Press out at the bottom of both of the
Drain Hose
Bucket
Vacuum
Break
Water Inlet /
ATC Sensor
Motor Start
Capacitor
4-
hose from the vacuum break.
Vacuum
Break
supports, and pull the vacuum break
from the rear panel slots.
Vacuum
Break
Push
Push
Hose Clamp