Out-Of-Balance Switch - Amana Speed Queen AWM190W2 Service Manual

34. OUT-OF-BALANCE SWITCH
a. Remove two screws from bottom edge of front
panel, Figure 20.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top,
Figure 20.
c. Hinge or remove cabinet top, paragraph 18.
d. Check for bent actuator arm or lever,
Figure 50.
IMPORTANT: If switch lever repeatedly trips the
out-of-balance switch, check centering of agitator
within the loading door opening. If tub module is
not centered within opening, centering spring(s)
may have been overstretched. Replace necessary
spring(s) and recheck centering, Figure 51.
ACTUATOR
ARM
OUT-OF-BALANCE
:L--f}
SWITCH ASSEMBLY
----=:: ~
~
=
-~==~
--~~ ~~===-------
Figure 50
59
HOLES
CENTERING
SPRING
Fi~ure
51
W308SE18
RS3100002 (37400R3)
Rev. 3