Keysight Technologies N9030B Installation Note page 4

Option CR3, or CRP, or ALV Installation Kit
Introduction
This kit contains all of the instructions required to install Option CR3, CRP, or ALV on a Keysight
N9030B PXA signal analyzer.
The rear panel AUX IF OUT port is present on all PXA signal analyzers, however each of the possible
output signal choices require a license.
Contents
Quantity Description
1 Installation Note
1 Option Upgrade Entitlement Certificate
4
At the time of manufacture the hard ware related to this option was fully
1.
adjusted and the option performance was verified to be within its
warranted specifications. Within one year of the initial calibration date
of the instrument this option is fully calibrated with no further
adjustment or verification testing.
To determine the initial calibration date, locate the original calibration
certificate that was shipped with the instrument at the time of
purchase. The Date of Calibration is printed on the original calibration
certificate.
To ensure that this newly installed option has been installed properly,
the procedure that follows includes a functional check.
The latest revision of the X-Series signal analyzer software may be
2.
downloaded from:
http://www.keysight.com/find/Xseries_software
This option is licensed for one instrument model/serial number
3.
combination. The license key will only install on the designated
instrument.
Keysight Part
Number
This note
5964-5178
Installation Note N9030-90079