Setting Mode 3 - Daiichi Electronics SVLC-110L Instruction Manual

5.3.3 Setting mode 3

Display mode
Setting mode 3 is selected by pressing SET and DISPLAY switches continuously for longer than 3 seconds.
Pushing MODE switch performs movement of setting item.
The present mode can be returned to the display mode by pressing DISPLAY switch.
< Caution >
If setting change should have been mistaken, a display and output of measurement are not obtained correctly.
Therefore, users must not set. The setting item without the corresponding option is not displayed.
(1) 311～312 Input circuit setting
Sets the phase wire of an input circuit, and an input voltage / phase voltage full scale.
Input circuit phase wire change
◆ 311 Input circuit phase wire change
Sets the input circuit and phase wire.
Selection by ＋ and － , set value is updated by pushing SET
3 seconds or more.
Default setting：3φ3W (No designation)
<Caution>
・If this setting is changed, all the settings of setting 1 and setting
2 will turn into a default setting of the input circuit after change.
・The right measurement cannot be performed if setting of actual
connection and phase wire are different.
＋
3φ3W
－
SET and DISPLAY
3 seconds
311～312
DISPLAY
Input circuit setting
MODE
321～326
DISPLAY
Analog output adjustment
MODE
311
RESET/SHIFT
＋
1φ3W 1φ3W
(U-W-N) (U-V-N)
－
－
＋
MAX/MIN
Input voltage
＋ ＋
1φ3W
1φ2W
(V-W-N)
－ －
36
Setting mode 3
MAX/MIN
312
RESET/SHIFT
New setting
Setting No.
Input circuit phase wire change
SVLC-212-175
Now setting