Setting Display - Daiichi Electronics SVLC-110L Instruction Manual

4.2.3 Setting display

It is the display at the case of various setting. There are three types of setting modes according to the
contents of a setting.
Operation and the contents of setting (detail) in setting mode, please refer to "5 Setting".
① Setting mode 1
Setting of a measurement display factor, an
alarm output, and an alarm value, and
backlight is performed.
And, an alarm output can be tested in this
setting mode.
② Setting mode 2
Setting of measurement range, analog output,
external operation input, and measurement
display ON/OFF is performed.
And, it can initialize settings in this
setting mode.
③ Setting mode 3
Setting of an input circuit is performed.
And, analog output can be adjusted in this
setting mode.
New setting
Now setting
Setting No.
New setting
Now setting
Setting No.
Setting factor
New setting
Now setting
Setting No.
(No.311 Input circuit phase wire change)
15
SVLC-212-175
Setting mode 1
(No.111 Display pattern)
Setting mode 2
(No.211 Voltage range)
Setting mode 3