Table of Contents
Advertisement
Removing the X-CUBE+LCD Unit
What has to be
The X-Cube+LCD unit has to be taken out of the projector.
done
Necessary Tools
Screwdriver 8 mm.
Necessary Parts
None
Electrical
Before removing the X-Cube, it must be electrically disconnected from the driver board.
disconnection of
Follow the next procedure:
the X-Cube.
Removing the X-
To remove the LCD + X-cube unit together with the Analog Buffer unit, follow the next
Cube+BufferUnit
procedure:
Illustration
BARCO ——————————————————— 7
Step
Action
1
Press very carefully on both sides of the
cable lock to unlock.
2
Pull out the cable.
3
Disconnect the power connection on top of
the Analog Buffer.
Step
Action
1
Loosen both fixation screws on the base of the X-cube
using a Philips screwdriver with a shaft of minimum 150
mm.
2
Take out the unit from the main frame very carefully.
Power connector
————————————— Projection Systems
Illustration
Press to unlock
connector
cable
Connector
Press to lock
Image
1
1
Cable connectors
Advertisement
Table of Contents
