Rangemaster Professional 90 Gas FSD User Manual page 27

The handles should be above the fixings.
Remove the 4mm Allen screws from the top corners of
the fascia and fix the front handrail in position.
Fitting a stability bracket
A stability bracket or chain (not supplied by with the
cooker) should be fitted when the cooker is connected
to a flexible gas supply.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
1. Place the cooker in its intended position and level
the cooker.
2. Draw a pencil line 70mm from the front edge of the
levelling feet.
3. Mark the centre line for the bracket by measuring
550mm from the left hand side of the cooker.
4. Lower the front roller and move the cooker forward.
5. Measure back from the pencil line 550mm to locate
the front edge of the bracket. Fix the bracket to the
floor.
6. Measure the height from floor level to engagement
edge in back of cooker. Add 3mm to this dimension
and assemble the stability bracket to this height.
(i.e. from floor level to underside of the top member)
and ensure the bracket does not foul the oven
burner assembly.
Gas Connection
A hose is not supplied by with the cooker. The Gas
supply needs to terminate with a down facing bayonet.
The rear cover boxes limit the position of the supply
point.
view from the rear
A position for gas supply connector
B appliance gas inlet
Because the height of the cooker can be adjusted and
each connection is different it is difficult to give precise
dimensions. Ideally the house supply bayonet should
be in the shaded area shown in the diagram. Although
a 3ft hose can be used, a 3ft6" or 4ft hose will allow
slightly more flexibility in the positioning of the bayonet
and make moving the cooker easier. The hose should
be fitted so that both inlet and outlet connections are
vertical so that the hose hangs downwards.
The connector is located just below the hotplate level at
the rear of the cooker.
For Natural Gas the flexible hose must be in
accordance with B.S.669.
For LP Gas it should be capable of 50mbar
pressure, 70 C temperature rise and carry a red
stripe, band or label.
If in doubt contact, your supplier.
Screw the threaded end of the hose into the gas inlet in
the underside of the connector block on the back of the
cooker.
27