Rangemaster Professional 90 Gas FSD User Manual page 18

A electrode notch
Now fit the two trim rings, making sure that they are
sitting down properly.
Griddle
Always clean the griddle after use. Allow to cool
completely before removing. Immerse the griddle
plate in hot soapy water. Use a soft cloth or, for
stubborn stains, a nylon washing up brush.
NEVER USE CAUSTIC OR ABRASIVE CLEANERS
AS THESE WILL DAMAGE THE SURFACE.
Control Panel and Doors
The control panel and control knobs should only be
cleaned with a soft cloth wrung out in clean hot soapy
water - but take care that no surplus water seeps
into the appliance. Wipe with a clean dampened
cloth then polish with a dry cloth. The oven doors
should only be cleaned with a soft cloth wrung out in
clean hot soapy water.
Cookers with window doors
On some models the oven door front panel can be
taken off so that the glass panels can be cleaned. If
the top edge of the oven door of your cooker has a
line of holes and there are screws in the side edges
then it can be taken apart for cleaning.
Move the cooker forward to gain access to the
sides (see the 'Moving the cooker' section of these
instructions).
Open the oven door slightly and remove the front
panel fixing screws from the door sides (two each
side).
B ignition electrode
some window doors only
Carefully lift off the outer door panel. The inside face
of the glass panels can now be cleaned - take care
not to disturb or wet the door insulation. Please note
that the door is triple glazed but the inner two panels
are fixed and should not be separated. After cleaning
carefully refit the outer door panel and replace the
side fixing screws.
Grill
The face of the grill burner will darken with use - this
is perfectly normal. Any fat or grease will burn off. Do
not try to clean it - the small holes could get blocked
and affect burner performance.
The grill pan and grid should be washed in hot soapy
water. After grilling meats or any foods that soil, leave
to soak for a few minutes in the sink immediately
after use. Stubborn particles may be removed from
the grid by using a nylon brush.
The Ovens
The Main oven
Cleaning is easier if carried out while the oven is still
warm. Before cleaning, cover the burner to prevent
the burner holes becoming blocked.
The inside of the oven and inner door panel can
be cleaned using any cleaner approved for use
on enamelled surfaces. Follow the manufactures
instructions.
Take care not to disturb the oven thermostat
temperature sensor at the top of the oven opening.
The enamelled oven burner trim (supplied with some
models only) can be removed for cleaning.
The oven burner trim hooks onto the front of the oven
burner bracket.
When refitting make sure that the trim is in the middle
of the front of the oven burner bracket.
18