Chemical Injection (Bz-105Lx-Auto Only); Auto-Fill And Pump-Out (Auto Units Only); After Use - Mytee Breeze BZ-102LX User Manual

2 - Machine Operation
2.5 - Chemical Injection (BZ-105LX-AUTO
Only)
Fill the included 5 qt. bottle with chemical concentrate of
your choice. With a cleaning tool connected, switch on
the pump and pull the trigger on your tool to keep water
flowing. Turn the chemical injection knob counter-clock-
wise to open the valve. This allows chemical to siphon
into the line. Turn the knob until you see the bubble reach
the desired gallons per hour of chemical. Follow chemical
manufacturer's instructions for correct ratio.
IMPORTANT: If chemical injection will not be used, make
sure the chemical injector is closed by turning the knob all
the way clockwise. ♦
2.6 - Auto-Fill and Pump-Out (AUTO Units
Only)
Auto-fill: Connect standard
garden hose from water
source to the auto-fill
connection on the front of
the unit. Turn on the water
source and let the tank
begin to fill. It will shut
off when the water level
reaches the float switch in
the solution tank.
Pump-out: Connect a
second standard garden
hose to the pump-out
connection and lay the
other end of the hose in a
draintable location. Activate
the pump-out switch on the
front of the machine and
open the ball valve on the
pump-out connection. The
Breeze™ will automatically drain recovered water from the
tank.
♦

2.7 - After Use

Emptying the recovery
tank: Place a bucket or
other appropriate recepta-
cle under the recovery tank
drain valve and pull up on
the drain valve lever to drain
dirty water.
Emptying the solution
tank: Connect a vacuum
hose to the Breeze™ and
turn on at least one of the
vacuums. Open the solution
tank lid and vacuum out
any left-over solution in the
tank. Once the solution tank
is empty, drain the recovery
tank by following the above
instructions.
♦
10