Connector Pin Assignment - DFI OPS150-CS Installation Manual

Connector Pin Assignment

The OPS Module enables the integration of a pluggable module and a
display panel by employing the defined interconnect based on the JAE and
HRS combo plug and their receptacle connectors. The right angle blind
mate plug connector (p/n: JAE TX25A-80P-LT-H1E) should be mated with
the receptacle connector (p/n: JAE TX24A-80R-LT-H1E); together, they
provide interfacing for the following functions:
Power: DC-IN +12V~+19V@12A max
Display Interface: 1*HDMI 2.0 (or DP, 4K at 60Hz)
Audio: left and right Channel
USB: 1*USB 3.0 and 2*USB 2.0
Control and Sensors: 1*UART and Consumer Electronics Control (CEC, note
that the OPS150-CS does not support this function)
Control and Management Signals: the OPS Module power status, power-on
via display panel, OPS Module detect, system fan control, and device
The following table lists the pin assignments of the 80-pin JAE connector:
Pins Pin Assignment Description I/O
40 +12V~+19V
+12V~+19V
39
+12V~+19V
38
37 +12V~+19V
+12V~+19V
36
+12V~+19V
35
+12V~+19V
34
+12V~+19V/NC
33
32 GND
31 DVI0_HPD
DVI0_DDC_CLK
30
DVI0_DDC_DATA
29
GND
28
Pins
(1)
80
Power -
Power - 79
Power - 78
77
Power -
Power - 76
Power - 75
Power - 74
Power/NC - 73
72
Ground -
71
DVI-D IN
DVI-D I/O 70
DVI-D I/O 69
Ground - 68
9
Pin
Description
Assignment
GND Ground
GND Ground
GND Ground
GND Ground
GND Ground
GND Ground
PWR_STATUS PowerGood
PS_ON# Pluggable Signal ON
Pluggable Board
PB_DET
Not Available Not Available
AZ_LINEOUT_R Audio-R ch
AZ_LINEOUT_L Audio-L ch
GND Ground
reset.
I/O
-
-
-
-
-
-
(2)
OUT(OC)
IN
OUT
Detect
I/O
OUT
OUT
-