VERITAS NetBackup 5330 Hardware Service Procedure page 9

HSP #133 Replacing a RAID canister in a Primary Storage Shelf or an Expansion canister in an Expansion Storage Shelf
7 Slide the cover to the rear of the canister and lift it away from the canister.
8 Move the small blue locking handle down to pull the battery out of the canister.
In the diagram:
• The blue locking handle is circled in red.
• The battery is indicated by a red box.
• The arrow at the left end of the battery shows the direction in which to insert the battery into
the replacement canister.
9 Remove the battery by sliding it towards the rear of the canister.
10 Locate the replacement canister.
11 Insert the battery into the battery compartment in the replacement canister.
12 Slide the battery towards the front of the replacement canister under the tabs along the sides of
the compartment.
13 Move the blue locking handle up to secure the battery circuit board to the replacement canister.
To make sure that the battery is seated correctly, you might need to slide it out and insert it again.
14 Reinstall the cover on the replacement canister by sliding the cover forward until the latch buttons
click.
9