Sound Mode; Manual Mode; Dimmer Function; Master/Slave Mode - ProLights UVPANEL18 User Manual

3.5 SOUND MODE

• Press the button MENU so many times until the display shows Snd.
• Press the button ENTER.
• You can set the microphone sensitivity pressing the button MENU so many times until the display show
SenS.
• Using the button UP/DOWN, select the desired value sensitivity (slow-fast) u0 - u100.
• Press the button ENTER to confirm.

3.6 MANUAL MODE

For the manual setting you can refer to the following guide:
• Press the MENU button until the display shows U--, then press the ENTER button to confirm your choice.
• Set the values d 0 - d255 through the UP/DOWN buttons to select the dimmer level.
• Press the ENTER button to confirm the choice.
• Set the values s 0 - s255 using the UP/DOWN buttons to select the strobe level.
• Press the ENTER button to confirm the choice.

3.7 DIMMER FUNCTION

Enter dIM to select dimmer mode and dimmer speed. When dimmer is set to OFF, the MASTER DIMMER is
linear. The Dim1/2/3 are speed modes of the non linear dimmer, dIM1 is the faster, while dIM3 is the slowest.
Note. The factory default setting is dIM3.

3.8 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 11).
• Use any one of the standalone modes for the master unit.
• Set the slaves to the same DMX modes.

3.9 LINKING

Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3 -pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.

3.10 DMX MODE

The UVPANEL18 is equipped with 2 DMX configuration.
• Press the button MENU so many times until shows 2 CH or 5 CH, and press the button ENTER to confirm.
The tables on page 12 indicate the operating mode and DMX value. The UVPANEL18 is equipped with 3
pole XLR connections.

3.11 DMX ADDRESSING

To able to operate the UVPANEL18 with a light controller, adjust the DMX start address for the first a DMX
UVPANEL18
9