Programming; Programming Keyboard Operating Parameters; Local Mode Programming - Function Codes And Settings; Table 2. Local Mode Programming Function Codes And Default Settings - Ultimate Technology 500 POS User Manual

Pos keyboard
Table of Contents

Advertisement

PROGRAMMING KEYBOARD OPERATING PARAMETERS

The operating parameters of the keyboard can be configured (programmed) remotely from the
host computer or locally at the keyboard. Keyboard programming in the remote mode sets the
keyboard parameters as commanded by the host computer input applied at the main
communications port. Selection of the local programming mode enables keyboard parameter
setup locally at the keyboard. Note that all keyboards come from the factory programmed with a
default set of parameters.
LOCAL MODE PROGRAMMING - FUNCTION CODES AND DEFAULT SETTINGS
A summary of all keyboard parameters programmable in the local mode, their assigned Function
Codes and factory default settings are given in Table 2.

Table 2. Local Mode Programming Function Codes and Default Settings

FUNCTION
CODE
00
Program Keyboard Primary Keys
01
Program Keyboard Secondary Keys
02
Copy Primary Keys to Secondary
Keys
08
Enable/Disable
Reader (MSR) Tracks
09
MSR Beep Configuration
1 0
MSR Channel 1,3 Prefix

PROGRAMMING

PARAMETER
Magnetic
Stripe
DEFAULT
SETTING
(XXh = Hex
Code In ASCII)
See default
Used to program primary keys on Series 500
Keyboard. The keys can be programmed to
have primary and secondary levels of function.
The primary function is activated when only the
designated key is pressed.
function is activated when both the Sec Op key
and
simultaneously.
program secondary key functions.
See default
See remarks above.
Used to copy primary key code into key
secondary position.
Channels 1,2
The magnetic card reader can read three
enabled
formats of information, two at any one time, on
standard format cards. This function is used
to select which tracks on the MSR are enabled
and/or disabled.
Beep on good
Useful for indicating a good or bad reading
and bad read
when card swiped through reader.
% (25h) for
U s e d
format 1
m a g n e t i c c a r d c h a n n e l .
; (3Bh) for
format 3
12
REMARKS
The secondary
designated
key
are
Use Function Code 01 to
t o
s e n d
a
p r e f i x
pressed
b e f o r e
t h e

Advertisement

Table of Contents
loading

This manual is also suitable for:

500 series

Table of Contents