Table of Contents
Advertisement
PROGRAMMING KEYBOARD OPERATING PARAMETERS
The operating parameters of the keyboard can be configured (programmed) remotely from the
host computer or locally at the keyboard. Keyboard programming in the remote mode sets the
keyboard parameters as commanded by the host computer input applied at the main
communications port. Selection of the local programming mode enables keyboard parameter
setup locally at the keyboard. Note: All keyboards come from the factory programmed with
a default set of parameters.
To program the Series 600 Keyboard in the local mode proceed as follows:
1. Connect main keyboard port to PC or Host, Aux keyboard port to IBM Compatible PC
keyboard.
2. Swipe the PROGRAM CARD supplied with the keyboard in the magnetic stripe reader MSR).
3. All LED indicators turn on and the keyboard annunicator beeps three times.
4. After step 3 is complete, LED indicator (1) will flash continuously to indicate that the keyboard
programming mode is active.
5. For a summary of the parameters that can be programmed in the local mode, refer to Table 3.
6. Follow the instructions given in Table 2 for the applicable Function Code(s) to program the
keyboard for the desired parameter(s). Note that sequence of instructions provided in Table 2
is in Function Code numerical order.
7. When programming is complete, exit the local programming mode by typing 99 on the Series
600 Keyboard numeric keypad or by swiping the Program Card. This returns the keyboard to
normal operation.
Series 600 POS Keyboard
PROGRAMMING
LOCAL MODE PROGRAMMING INSTRUCTIONS
Some programming options may not be
activated until the keyboard is re-powered.
Serial port communication selections --
Function Codes 20-24; 30-34; 91.
NOTE
13
Advertisement
Table of Contents
