Ultimate Technology 500 POS User Manual page 31

Table 3. Local Mode Programming Instructions - Continued
Function Code(s)
19
MSR Send
20 or 30
Comm (RS232)
Main Port 0 (20)
AUX Port 1 (30)
Baud Rate
Note: *Default Settings
Operation Normal Indication
4. Program the next function code or exit programming mode by entering 99
on Series 500
Programmer's card.
switch out of the AUX position.
1. While in programming mode, at the Series 500 Keyboard numeric keypad, enter
applicable Function Code 19.
LED (2) turns on.
2. At the Series 500 Keyboard numeric keypad, enter the applicable number (0 or 1) per
list below to select MSR data from one or both good tracks.
0 = send any good track*
1 = send only if all enabled tracks good
3. Program the next function code or exit programming mode by entering 99 on Series
500 Keyboard numeric keypad or by swiping the Programmer's card. If using the
optional 3-position keyswitch, move switch out of the AUX position.
1. While in programming mode, at the S eries 500 keyboard numeric keypad, enter
Function Code 20 (Port 0) or 30 (Port 1).
LED (2) turns on.
2. At Series 500 Keyboard numeric keypad, enter the applicable number (1 through 9)
to select baud rate per list below.
1 = 300
2 = 600
3 = 1200
4 = 2400
5 = 4800
LED (2) turns off.
3. Program the next function code or exit programming mode by entering 99 on Series
500 Keyboard numeric keypad or by swiping the Programmer's card. I f using the
optional 3-position keyswitch, move switch out of the AUX position.
Remarks
Keyboard numeric
If using the optional 3-pos ition keyswitch, move
6 = 9600*
7 = 19200
8 = 38400
9 = 57600
23
keypad or by swiping the