Ultimate Technology 500 POS User Manual page 30

Table 3. Local Mode Programming Instructions - Continued
Function Code(s) Operation
14 1. While in programming mode, at the Series 500 Keyboard numeric
15
16
Magnetic Stripe
Reader (MSR)
Channel 2 2. At the auxiliary keyboard, press the desired key or type the desired key
Prefix (14)
Field
Separator (15)
Suffix (16)
3. At the Series 500 Keyboard, press ENTER.
4. Program the next function code or exit programming mode by entering 99
17 1. While in programming mode, at the Series 500 Keyboard numeric
18
Magnetic Stripe
Reader (MSR)
Channel 1,3
Bad Read (17) 2. At the auxiliary keyboard, press the desired key or type the desired key
Channel 2
Bad Read
Macro (18)
3. At the Series 500 Keyboard, press ENTER.
Note: *Default Settings
Normal Indication
the Programmer's card. If using the optional 3-position keyswitch,
move switch out of the AUX position.
keypad, enter applicable Function Code 14, 15, or 16.
LED (2) flashes.
sequence. Note that the maximum number of key codes is limited to 24
- this is equivalent to approximately 12 key strokes.
LED (2) turns off.
on Series 500 Keyboard numeric keypad or by swiping the Programmer's
card. If using the optional 3-position keyswitch, move switch out of the
AUX position.
keypad, enter applicable Function Code 17 or 18.
LED (2) flashes.
sequence. Note that the max imum number of key codes is limited to 24
- this is equivalent to approximately 12 key strokes.
LED (2) turns off.
Remarks
If the
beeps
while entering key codes at the
auxiliary
exceeded 24 key codes. Repeat
steps 1 and 2.
If the
beeps and LED (2) turns off
while entering key codes at the
auxiliary
exceeded 24 key codes. Repeat
steps 1 and 2.
22
Series 500 Keyboard
and LED (2) turns off
keyboard, you have
Series 500 Keyboard
keyboard, you have