Advertisement
CRAFTAP 3 | Brief Maintenance Manual
14
Remove the backing plate from the bottle tray. Twist
off the pouring head bushing, detach the gasket,
remove the seal from the groove, and remove
the gasket from the hole. Wipe the removed
components with a sponge dipped in warm
water with a mild detergent.
15
Wipe the inside surface of the flask with a sponge
dipped in warm water with a mild detergent. Then
wipe the inside and outside surfaces of the flask
with a clean wet cloth. Wipe the flask thoroughly
inside and outside with a clean lint-free cloth
until dry.
Before pouring the beverage
Drain the water from the beverage supply line into
the empty flush tank. Keep draining the remaining
liquid until the beverage starts to flow into the
beverage container.
Detailed instructions and assembly video are available at http://beerinnovations.com
Rinse the parts under running water and wipe them
dry with a clean lint-free cloth. Perform assembly
in reverse order.
16
In order to maintain cleanliness, do not drain water
used for flushing at the last treatment stage from
the beverage supply line until subsequent use
of the dispenser. Connect the intake head removed
from the flush keg to the beverage keg.
Do not forget to close the door when
using the dispenser for dispensing.
11
Advertisement
