Advertisement
CRAFTAP 3 | Brief Installation and Connection Manual
4
Place the dispenser on the counter top by aligning
it with the pre-drilled holes. Insert power cord
through rear hole.
6
Insert the shaft into the central hole under
the counter top so that the threaded shaft
end protrudes out of the cam hole.
flask drain
8
gas
(white)
(GAS)
Connect the gas, beverage supply, and drain hoses
(flask and dispensing assembly) with the appropriate
dispenser tubes using JG-connections included
in a standard set.
Ensure the gas supply from the cylinder
is shut off
Detailed instructions and assembly video are available at http://beerinnovations.com
Put on the washers, screw the nuts onto the studs,
and fix the dispenser on the table board by
tightening the nuts with a wrench.
Screw the bottle tray on the end of the shaft with
a backing plate on it as well as the handles to the
appropriate locations.
dispensing assembly
drain (green)
(DRAINAGE)
beverage (red)
(BEER)
Connect the power adapter to the appropriate
device connector under the table board.
Connect the device to the power supply line.
Ensure that the network settings
conform to the dispenser's specifications
5
7
9
6
Advertisement
